|
This gateway can read BACnet data from your BACnet IP devices and publish it as BACnet MSTP data.
It can also write to the BACnet IP devices.
This gateway can also do the reverse, read BACnet MSTP data and publish it as BACnet IP data.
It can also write to the BACnet MSTP devices.
In summary, this gateway can act as:
Client/Master on the BACnet IP network: Hence it is capable of reading data from the various BACnet slave devices and writing data to them if required.
Server/Slave on the BACnet IP network: You can use the gateway in this mode if you have a BACnet IP master on the network which would be reading data from the gateway.
Client/Master on the BACnet MSTP network: Hence it is capable of reading data from the various BACnet MSTP devices and writing data to them if required.
Server/Slave on the BACnet MSTP network: The gateway can be configured to be a server of data values, hence another BACnet MSTP client can read data from the gateway and write data into the gateway.
|
|
QuickServer Key Features:
- BACnet Testing Laboratory (BTL) Mark
- Ability to interface up to 250 points of common BAS protocols
- Multi-configuration capability; specific configurations selectable via DIP switches or software
- Flat panel mount standard, DIN rail mount option
- DIP switches to select baud rate or node ID on the fly
BACnet MS/TP driver:
- Driver type: Client or Server
- Data Link layer: MS/TP master (Clause 9), baud rate up to 38.4 Kbps, MS/TP slave (Clause 9), baud rate up to 38.4 Kbps
- Connection type: RS-485 (two wire, half duplex)
- Baud rates: 9600, 38400, 76800
- BACnet COV support for fast data communication while reducing traffic over a BACnet network
- Data types supported:
- AI - Analog Input Object
- AO - Analog Output Object
- AV - Analog Value Object
- BI - Binary Input Object
- BO - Binary Output Object
- BV - Binary Value Object
- MI - Multi-state Input Object
- MO - Multi-state Output Object
- MV - Multi-state Value Object
BACnet/IP driver:
- Driver type: Client or Server
- Data Link layer: BACnet IP, (Annex J)
- Connection type: BACnet/IP Internet Protocol (IP), 10/100BaseT, BBMD supported
- Data types supported:
- AI - Analog Input Object
- AO - Analog Output Object
- AV - Analog Value Object
- BI - Binary Input Object
- BO - Binary Output Object
- BV - Binary Value Object
- MI - Multi-state Input Object
- MO - Multi-state Output Object
- MV - Multi-state Value Object
- BACnet is a trademark of ASHRAE
-We will configure the gateway for you based on your requirement and support you during commissioning of the gateway, so you do not have to worry about configuring the FieldServer gateway.
-However, it is very helpful to know how to configure the devices. All the required tools and supporting product manuals with be provided completely free of cost with your purchase.
-Configuration of the FieldServer is done using a '.csv' file. This file can be edited using any text editor (example Microsoft excel).
-In this file we need to enter information for the Client and Server side interfaces of the FieldServer. This includes but is not limited to:
Node ids of the slave devices
IP addresses/device address of the slave devices
Baud rate, parity, stop bits for serial communication
Scan rates
- And finally we need to create an internal mapping that would map each data value read on the client side to a data value on the server side.
-For detailed information on configuration please get in touch with us and review the configuration manual on top of this page