|
A great solution to interconnect Modbus (Modbus RTU, Modbus TCP, Modbus ASCii) Devices on other protocol Networks like Bacnet, Lonworks, SNMP, Metasys N2, M-Bus, KNX and others.
 |
Downloads
Protocol Datasheets
Modbus RTU
Modbus TCP
Hardware Datasheets
QuickServer
FS-3510
Configuration Manuals
Modbus RTU
Modbus TCP
|
- FieldServer’s Modbus Gateway is a great solution to enable two way communication between:
- Two different types of Modbus Networks or devices, for example a Modbus RTU network/Device and a Modbus TCP network/device.
- Between a Modbus RTU network/device and a different protocol network like BACnet, Lonworks, SNMP, Metasys N2, M-Bus or KNX.
- Between a Modbus TCP network/device and a different protocol network like BACnet, Lonworks, SNMP, Metasys N2, M-Bus or KNX.
- Between a Modbus ASCii network/device and a different protocol network like BACnet, Lonworks, SNMP, Metasys N2, M-Bus or KNX.
- Fieldserver Modbus Gateway models have multiple RS-485 and RS-232 ports and an Ethernet port. Hence it is possible to interconnect devices on different serial and Ethernet protocols together.
Popular combinations for Modbus TCP gateways
FieldServer Hardware platforms supporting Modbus protocol
|
Device type
|
RS 485/232 ports
|
Lonworks Ports
|
Available Ethernet ports
|
Base Point count capacity
|
Extended Point count capacity
|
|
QuickServer
|
2
|
0
|
1
|
250
|
1000
|
|
QuickServer Lonworks
|
1
|
1
|
1
|
250
|
1000
|
|
Enhanced QuickServer
|
2
|
0
|
1
|
500
|
1000
|
|
Enhanced QuickServer Lonworks
|
1
|
1
|
1
|
500
|
1000
|
|
FS-B2010
|
1
|
0
|
1
|
500
|
5000
|
|
FS-B2011
|
1
|
1
|
1
|
500
|
5000
|
|
FS-B2510
|
2
|
0
|
1
|
500
|
5000
|
|
FS-B3510
|
5
|
1
|
2
|
1000
|
10000
|
How to configure the FieldServer Gateway?
- We will configure the Gateway for you based on your requirement and support you during commissioning of the Gateway, so you do not have to worry about configuring the FieldServer Gateway.
- However, it is very helpful to know how to configure the devices. All the required tools and supporting product manuals with be provided completely free of cost with your purchase.
- Configuration of the FieldServer is done using a '.csv' file. This file can be edited using any text editor (example Microsoft excel).
- In this file we need to enter information for the Client and Server side interfaces of the FieldServer. This includes but is not limited to:
- Node ids of the slave devices
- MSTP addresses/device address of the slave devices
- Baud rate, parity, stop bits for serial communication
- Scan rates
- And finally we need to create an internal mapping that would map each data value read on the client side to a data value on the server side.
- For detailed information on configuration please get in touch with us and review the configuration manual on top of this page